当前位置: 首页 > 协会标准 > ASTM 美国材料与试验协会 > ASTM D5904-2002 用紫外线、过硫酸盐氧化物和薄膜导电率检测法测定水中总含碳量、有机碳和无机碳的标准试验方法
ASTM D5904-2002 用紫外线、过硫酸盐氧化物和薄膜导电率检测法测定水中总含碳量、有机碳和无机碳的标准试验方法
世界资料网 / 2020-01-30
【英文标准名称】: Standard Test Method for Total Carbon, Inorganic Carbon, and Organic Carbon in Water by Ultraviolet, Persulfate Oxidation, and Membrane Conductivity Detection
【原文标准名称】: 用紫外线、过硫酸盐氧化物和薄膜导电率检测法测定水中总含碳量、有机碳和无机碳的标准试验方法
【标准号】: ASTM D5904-2002
【标准状态】: 现行
【国别】:
【发布日期】: 2002
【实施或试行日期】:
【发布单位】: 美国材料与试验协会(US-ASTM)
【起草单位】: D19.06
【标准类型】: (Test Method)
【标准水平】: ()
【中文主题词】: 分析方法;试验;碳含量;水质
【英文主题词】: carbon; carbon-dioxide; inorganic-carbon; low-temperature-oxidation; membrane-conductivity-detection; organic carbon; total carbon
【摘要】: This test method is used for determination of the carbon content of water from a variety of natural, domestic, and industrial sources. In its most common form, this test method is used to measure organic carbon as a means of monitoring organic pollutants in high purity and drinking water. These measurements are also used in monitoring waste treatment processes. The relationship of TOC to other water quality parameters such as chemical oxygen demand (COD) and total oxygen demand (TOD) is described in the literature.5 1.1 This test method covers the determination of total carbon (TC), inorganic carbon (IC), and total organic carbon (TOC) in water in the range from 0.5 to 30 mg/L of carbon. Higher levels may be determined by sample dilution. The test method utilizes ultraviolet-persulfate oxidation of organic carbon, coupled with a CO2 selective membrane to recover the CO2 into deionized water. The change in conductivity of the deionized water is measured and related to carbon concentration in the oxidized sample. Inorganic carbon is determined in a similar manner without the requirement for oxidation. In both cases, the sample is acidified to facilitate CO 2 recovery through the membrane. The relationship between the conductivity measurement and carbon concentration is described by a set of chemometric equations for the chemical equilibrium of CO2, HCO3- , H+, and the relationship between the ionic concentrations and the conductivity. The chemometric model includes the temperature dependence of the equilibrium constants and the specific conductances.1.2 This test method has the advantage of a very high sensitivity detector that allows very low detection levels on relatively small volumes of sample. Also, use of two measurement channels allows determination of CO2 in the sample independently of organic carbon. Isolation of the conductivity detector from the sample by the CO2 selective membrane results in a very stable calibration, with minimal interferences.1.3 This test method was used successfully with reagent water spiked with sodium bicarbonate and various organic materials. It is the user's responsibility to ensure the validity of this test method for waters of untested matrices.1.4 This test method is applicable only to carbonaceous matter in the sample that can be introduced into the reaction zone. The injector opening size generally limits the maximum size of particles that can be introduced.1.5 In addition to laboratory analyses, this test method may be applied to on line monitoring.1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
【中国标准分类号】: Z16
【国际标准分类号】: 13_060_50
【页数】: 7P.;A4
【正文语种】:

关键字: ASTM D590

相关资料

ASTM D5904-2002 用紫外线、过硫酸盐氧化物和薄膜导电率检测法测定水中总含碳量、有机碳和无机碳的标准试验方法
ASTM D5904-2002 用紫外线、过硫酸盐氧化物和薄膜导电率检测法测定水中总含碳量、有机碳和无机碳的标准试验方法
ASTM F2204-2002 滨线响应技术描述用标准指南
ASTM B427-2002 齿轮用青铜合金铸件标准规范
ASTM D732-2002 用穿孔工具测量塑料剪切强度的标准试验方法
ASTM D953-2002 塑料支承强度的标准试验方法
ASTM D1968-2002a(2007) 纸和纸制品相关术语
ASTM E925-2002 光谱狭缝宽度不超过2nm的紫外线-可见光分光光度计的校准监测的标准实施规程
ASTM F1604-2002 冰淇淋、软饮料、牛奶冰淇淋冷柜标准规范
ASTM B452-2002 电子设备用包铜钢导线标准规范
ASTM E2195-2002e1 与咨询文件检验相关的标准术语
ASTM F918-2002 不掺碳酸气的机械冷藏饮料自动售货机(可见产品)的标准规范
ASTM D5291-2002(2007) 仪器测定石油产品及润滑剂中碳、氢和氮含量的标准试验方法
ASTM D6588-2002 轮胎棱疲劳的标准试验方法(盘式疲劳试验)
ASTM F1961-2002a 交联聚乙烯(PEX)管用带盘簧的金属机械冷扩口加压管件的标准规范
ASTM D5891-2002 土工合成粘土衬的粘土成分流失的标准试验方法
ASTM G98-2002 材料耐磨损性的标准试验方法
ASTM F2182-2002a 磁共振成象时测量射频感应加热接近被动性植入物的标准试验方法
ASTM C1543-2002 利用池塘法测定氯化物渗透到混凝土中的标准试验方法
ASTM C597-2002 对通过混凝土的脉冲速度的标准试验方法
ASTM E1824-2002 拉力下热机械分析的玻璃转变温度分配的标准试验方法
ASTM D2111-2002(2007) 卤化有机溶剂及其混合物的比重和密度的标准试验方法
ASTM D1508-2002(2007) 碳黑、球状细粒磨损的标准试验方法
ASTM F1277-2002 用离子选择电极技术测定包装和衬垫材料中可沥虑氯化物的标准测试方法
ASTM D4832-2002 被控制的低强度材料测试筒的制备和测试的标准检测方法
ASTM C1311-2002 溶剂释放器密封剂的标准规范
ASTM C1206-2002 铁(II)/铬(VI)安培计滴定法测定钚的试验方法
ASTM E2215-2002 评价轻水核电反应堆监视舱的标准实施规程
ASTM E185-2002 轻水冷却核反应堆容器的监督程序设计的标准操作规程
ASTM D6815-2002a 木制和木基产品的荷载和蠕变效应的持续时间的评价的标准规范
ASTM E1838-2002 利用成人自愿者试验液体卫生洗手剂的去除病毒有效性的标准试验方法
ASTM F811-2002 机动车辆的轮胎试验用加速度计的标准实施规程

用户评论(共0条评论)

  • 暂时还没有任何用户评论
总计 0 个记录,共 1 页。 第一页 上一页 下一页 最末页
用户名: 匿名用户
E-mail:
评价等级:
评论内容: